Limewash Stucco and Concrete in Kent

Typical cost in Kent

  • One wall or garden wall, about 300 sq ft$1,000 – $2,400+
  • One-story stucco house, about 1,500 sq ft$5,500 – $12,000+
  • Two-story stucco house, 2,000–2,500 sq ft$7,000 – $18,000+

Once porous cement-based surfaces like stucco, block and poured concrete are clean and sound, lime replaces a flat painted look with a softly clouded, plaster-like finish. We handle limewash painting for them on homes, garden structures and basements in Kent.

Cement surfaces are alkaline and differ widely in texture and in how much water they take up, so before anything else we check that the surface is ready and try a patch on the real wall. Stucco and concrete jobs cover Kent, Des Moines, Covington, SeaTac, Auburn, Tukwila and Maple Valley.

Request a free quote

Stucco cottage finished in warm sand-colored limewash

Stucco and concrete limewash options

Cement stucco exteriors

What is already on the stucco decides the preparation. Bare or previously limewashed cement stucco is ready once clean. Where the stucco carries acrylic paint in good order, a bonding primer approved by the limewash maker comes first, whereas elastomeric coatings generally have to be removed. We fill fine cracks so rain cannot get in behind the lime. The finish is a gentle shift in tone on smooth or sand-textured stucco.

New stucco

Fresh stucco has to cure first. One limewash maker asks for roughly 21 to 28 days on newly applied Portland cement stucco; other makers set their own waiting times. The product and the stucco’s condition decide when it is ready, and going on too early can leave blotchy color.

Concrete block and cinder block

On concrete or cinder block, joints and faces absorb at different rates, so we work the first coat into the texture and follow with a finish coat to even it out. The result takes the hard, utilitarian edge off block garages, garden walls and foundations.

Poured concrete walls

Poured walls often carry form-release residue, curing compounds or sealers that cut absorption, so we clean and run an absorption test before any sample. Board-formed and poured concrete, inside or out, can then be limewashed toward a softer, stone-like tone.

Basement and garage walls

A damp basement needs its water problem solved first, since limewash will not stop active leaks or hydrostatic pressure. On a dry masonry wall, this traditional breathable finish brightens the space without trapping moisture behind a film.

Close view of soft clouded limewash texture in raking light

Is your stucco or concrete ready?

We check for cracks, hollow spots, salt bloom, old coatings and water repellents. Acrylic paint and elastomeric coatings both stop lime soaking in. Sound acrylic paint can be primed instead of stripped where the limewash maker offers a bonding primer for it; elastomeric coatings normally have to come off, and at least one major maker rules them out.

Outdoors, stucco and concrete follow the same weather rules as brick and stone. We put coats on in mild, dry conditions and shelter them from rain and strong sun until they have cured.

Looks that suit stucco

Once the stucco is ready, warm sand, chalk and light clay tones bring out its texture. Darker earth colors tend to work on outbuildings and garden walls. A sample brushed onto a board with the same texture as your stucco shows how much movement to expect.

Request a free limewash quote

For a cement-based wall, let us know whether it is stucco, block or poured concrete, what paint or sealer may already coat it, and where the property is. We'll get back to you soon with an estimate or any questions we have. Estimates are free and there's no obligation.

Call (253) 867-9998

Call (253) 867-9998